Getting Fences and Gates Ready for Coastal Storm Season
On the Oregon and Washington coast, the first strong fall storm usually finds the weak spots in a fence. A solid board fence acts like a sail, catching wind along its whole length, and all of that force ends up at the posts. A post that has been rotting at the ground line for a few years can hold through a calm summer and then snap or lean in one gusty night, taking several panels with it. A careful walk along the fence line at the end of September, while the weather is still calm, gives you time to fix what you find.
Start at the posts
Posts are where most fence failures begin. Push firmly near the top of each one; a sound post moves very little, while one that rocks has a problem at or below grade. Pull back the soil or mulch at the base and probe the wood at the ground line with a screwdriver, since that is where moisture and air together cause rot. Look for concrete footings that have cracked or that form a cup holding water against the wood. Also check whether soil, bark, or plantings have built up against the bottom of the fence over the years, keeping the boards wet.
Check rails, boards, and fasteners
Next, look at the horizontal rails and the boards fastened to them. Rails that have split, sagged, or pulled away from the posts pass wind load poorly. Loose or missing boards leave gaps that let wind catch the edges and rip more boards free. Salt air corrodes fasteners and hardware faster on the coast than inland, so look for rust streaks, nail heads that have backed out, and screws that no longer bite. Replacing failing fasteners with corrosion-resistant ones suited to the lumber is a small job that adds a lot of strength.
Gates take the most abuse
Gates move every day, hang their weight from a single post, and slam in the wind if the latch is weak, so they are often the first part of a fence to give out. Warning signs include a gate that drags on the ground, a latch that no longer lines up, hinges pulling out of the post, and a hinge post leaning toward the opening. A diagonal brace or an anti-sag kit can sometimes square up a gate, but if the hinge post itself is loose, the real fix is resetting or replacing that post. Make sure the latch holds the gate firmly closed in wind, and add a drop rod to double gates.
A quick pre-storm checklist
- Posts that rock or lean out of plumb
- Soft or crumbling wood at the ground line
- Rails split or pulling away from posts
- Rusted, loose, or missing fasteners and hinges
- Gates that drag, sag, or will not stay latched
- Soil, mulch, or plants piled against the boards
Repair a section or replace the run
A fence with one or two bad posts and a few loose boards is usually a good candidate for repair. The old post and footing are removed, a new post is set with drainage at the base, and sound rails and boards are reattached. When rot shows up on many posts at once, the boards are badly weathered, or the fence has failed more than once, rebuilding the run is often the better use of money. On exposed lots, designs that let some wind pass through, such as boards with small gaps or an open top section, can reduce the load on the posts. Before building or changing a fence near a property line, check height limits and setback rules with your city or county.
Alejos Construction & Landscape builds and repairs wood and composite fences and gates for homes along the Oregon and Washington coast, from Warrenton and Astoria to Seaside, Cannon Beach, and the Long Beach Peninsula. If your fence is leaning or a gate will not stay shut, call (503) 791-0190 for a free estimate before the next storm.